|
|
| |
Analog Input Channels:
|
|
This is the maximum number of analog channel inputs. The single-ended number is specified when single-ended inputs are available as twice the number of differential inputs. Differential channels use the difference between two signals as an input; common mode is filtered out. In some systems, differential inputs are combinations of two single-ended inputs. When this is the case, twice the numbers of differential channels are available as single-ended inputs.
|
| |
Search Logic:
|
|
All matching products will have a value greater than or equal to the specified value.
|
|
| |
Differential Channels
|
|
Differential channels have two inputs. The signal to process is the voltage (V) difference between the two inputs. For example, if one reading is 4.93 V and the other reading is 5.16 V, the meaningful value is the 0.23 V difference between the two. Often, this applies to precision measurements where the difference between two low voltage inputs is small but critical.
|
| |
Search Logic:
|
|
"Required" and "Must Not Have" criteria limit returned
matches as specified. Products with optional attributes
will be returned for either choice.
|
|
| |
Accuracy:
|
|
Accuracy depends on the signal conditioning linearity, hysteresis, temperature considerations, etc. It is represented here as percent full scale of measurement range.
|
| |
Search Logic:
|
|
All matching products will have a value less than or equal to the specified value.
|
|
| |
Bandwidth:
|
|
Bandwidth is the difference between the high and low limits of the frequency response, typically defined by a variation from a nominal value by a stated value such as 3 dB.
|
| |
Search Logic:
|
|
All matching products will have a value greater than or equal to the specified value.
|
|
| |
Maximum Output:
|
|
This is the limit of output voltage.
|
| |
Search Logic:
|
|
All matching products will have a value greater than or equal to the specified value.
|
|
| |
Signal Isolator
|
|
Signal isolation is the separation of any direct electrical contact of a signal. This can be done in various ways including optical isolation, capacitors, and magnetic induction.
|
| |
Search Logic:
|
|
"Required" and "Must Not Have" criteria limit returned
matches as specified. Products with optional attributes
will be returned for either choice.
|
|
| |
Multiplexer
|
|
Handles several inputs and serially combines them into one output for transmission. Some multiplexers perform the reverse function.
|
| |
Search Logic:
|
|
"Required" and "Must Not Have" criteria limit returned
matches as specified. Products with optional attributes
will be returned for either choice.
|
|
