|
Search other suppliers in the following categories:
|
|
Chip resistors are passive resistors with a form factor of an integrated circuit (IC) chip. Typically, they are manufactured using thin-film technology.
|
|
DC-DC converter chips provide a regulated DC voltage output from a different, unregulated input voltage.
|
|
Digital potentiometers are three-terminal resistors with an adjustable center connection. To set the output resistance, a digital signal is sent through an electrical interface.
|
|
Force and load sensors covers electrical sensing devices used to measure tension, compression, and shear forces.
|
|
Humidity measurement instruments test for absolute humidity, relative humidity, or dew point in air.
|
|
IC voltage regulators are three-terminal devices that provide a constant DC output voltage that is independent of the input voltage, output load current, and temperature. IC voltage regulators are used in power supplies that hold their output voltage constant over a wide range of load variations.
|
|
Moisture meters are used to measure the moisture content in bulk solids, liquids and gases.
|
|
Piezoelectric devices generate electrical signals in response to vibrations and produce mechanical energy in response to electrical signals. Device types include actuators, motors, sensors, and transducers.
|
|
Piezoelectric sensors measure the electrical potential caused by applying mechanical force to a piezoelectric material. They are used in a variety of pressure-sensing applications.
|
|
Potentiometers, rheostats and trimmers are three-terminal resistors that are used to measure or divide voltages, and to protect or control circuits.
|
|
Pressure sensors include all sensors, transducers and elements that produce an electrical signal proportional to pressure or changes in pressure.
|
|
Printed circuit board (PCB) fabrication services design and fabricate circuit boards. They differ from electronic manufacturing services, which populate and assemble boards.
|
|
Printed circuit materials have copper-clad surfaces for the fabrication of electronic and electrical circuitry on printed circuit boards (PCBs), printed wiring boards (PWB) and flexible circuits. They include materials for flexible film circuit and membrane switches, as well as rigid laminates for circuit boards
|
|
Pushbutton switches are mechanical switches defined by the method used to activate the switch. The activation method is typically in the form of a plunger that is pushed down to open or close the switch.
|
|
Resistors are electrical components that oppose the flow of either direct or alternating current. They are used to protect, operate, or control circuits.
|
|
Resistors and potentiometers are passive electronic components that oppose the flow of either alternating current (AC) or direct current (DC).
|
|
Switches are used to allow electric current to flow when closed. When opened, they prevent current flow. Common switch types include pushbutton, rocker, toggle, rotary coded DIP, rotary DIP, key lock, slide, snap action, and reed.
|
|
Temperature instruments use contact or noncontact methods to measure temperature. Products include dial, digital, industrial and laboratory thermometers; temperature probes, indicators, and sensors; RTD elements and transmitters; and thermistors, thermocouples, thermopiles, and thermal switches.
|
|
Thermistors are thermally-sensitive devices whose electrical resistance varies with temperature. Unlike RTDs and thermocouples, thermistors do not have standards associated with their resistance vs. temperature characteristics or curves.
|
|
Varistors are voltage-clamping devices that can absorb current without damage. They are typically used in surge protection devices.
|
