|
Search other suppliers in the following categories:
|
|
Ball valves provide tight shut-off and characterizable control. They have high rangeability due to the design of the regulating element, without the complications of side loads typical of butterfly or globe valves.
|
|
Butterfly valves control flow through a circular disc or vane by turning the valve's pivot axis at right angles to the direction of flow in the pipe. They are normally used as throttling valves to control flow.
|
|
Centrifugal pumps consist of a set of rotating vanes, enclosed within a housing or casing, that are used to impart energy to a fluid through centrifugal force.
|
|
Check valves are self-activating safety valves that permit gases and liquids to flow in only one direction, preventing process flow from reversing. They are classified as one-way directional valves.
|
|
Diaphragm valves close by means of a flexible diaphragm attached to a compressor.
|
|
Electric valve actuators mount on valves which, in response to a signal, automatically move to a desired position using an outside power source. Single-phase or three-phase AC or DC motors drive a combination of gears to generate the desired torque level.
|
|
Flow meters (flowmeters) and flow sensors are devices used for measuring the flow rate or quantity of a moving fluid or gas.
|
|
Gate valves and knife valves are linear motion valves in which a flat closure element slides into the media stream to shut off flow.
|
|
Gearboxes and gearheads are speed reducers that consist of a set of gears, shafts, and bearings in an enclosed housing. In converting inputs to outputs, they reduce RPM and increase torque.
|
|
Globe valves are linear motion valves with rounded bodies, from which their name is derived. They are widely used in industry to regulate fluid flow in both on/off and throttling service.
|
|
Industrial lubricants are oils, fluids, greases and other compounds designed to reduce friction, binding or wear and exclude moisture. Specialized characteristics may enhance thermal conduction across thermal interfaces or reduce electrical resistivity across electrical joints.
|
|
Quarter-turn plug valves use a cylindrical or tapered plug with a hole in the center to control straight through flow when in the open position.
|
|
Pneumatic valve actuators adjust valve position by converting air pressure into linear or rotary motion.
|
|
Valve actuators mount on valves and, in response to a signal, move a valve to a desired position using an outside power source.
|
