|
Search other suppliers in the following categories:
|
|
Ball valves provide tight shut-off and characterizable control. They have high rangeability due to the design of the regulating element, without the complications of side loads typical of butterfly or globe valves.
|
|
Butterfly valves control flow through a circular disc or vane by turning the valve's pivot axis at right angles to the direction of flow in the pipe. They are normally used as throttling valves to control flow.
|
|
Cable transits are bulkhead or barrier modules that allow electrical cables to pass through, while providing various levels of sealing, strain relief, and damage protection, depending on the application requirements.
|
|
Check valves are self-activating safety valves that permit gases and liquids to flow in only one direction, preventing process flow from reversing. They are classified as one-way directional valves.
|
|
Control valves or proportional valves are power-operated devices used to modify fluid flow or pressure rate in a process system.
|
|
Electric valve actuators mount on valves which, in response to a signal, automatically move to a desired position using an outside power source. Single-phase or three-phase AC or DC motors drive a combination of gears to generate the desired torque level.
|
|
Gate valves and knife valves are linear motion valves in which a flat closure element slides into the media stream to shut off flow.
|
|
Globe valves are linear motion valves with rounded bodies, from which their name is derived. They are widely used in industry to regulate fluid flow in both on/off and throttling service.
|
|
Hose fittings are a category of components used to connect hoses and tubes for in-line, offset, multi-port, and mounting configurations.
|
|
Industrial pipe is a broad category of fluid and solid transport hardware used in many applications and industries. Cylindrical pipe and rigid tube is used in process, energy, construction, and civil infrastructure applications.
|
|
Industrial valves are classified in many different ways. They can be distinguished by material of construction, media handled, and/or application.
|
|
Manual valve actuators do not require an outside power source. They use a handwheel or lever to drive a series of gears whose ratio results in a higher output torque compared to the input (manual) torque.
|
|
Marine products and equipment are designed for use aboard boats and ships, on docks and piers, and in various saltwater and fresh water applications.
|
|
Pipe fittings cover many components that connect pipe ends for in-line, offset, multi-port, and mounting configurations.
|
|
Pipe transits are bulkhead or barrier modules allowing pipe, tubing, or other conduit to pass through, while providing various levels of sealing, strain relief, and damage protection, depending on the application requirements.
|
|
Pneumatic valve actuators adjust valve position by converting air pressure into linear or rotary motion.
|
|
Solenoid valves are devices that use a solenoid to control valve activation.
|
|
Strainers are placed in-line with process piping to remove large solid contaminants from the flow. Strainers can be cleaned and reused.
|
|
Tube fittings connect runs of tubing for in-line, offset, multi-port, and mounting configurations to other tubing sections, pipe, hose, and other fluid transfer components.
|
|
Tubing is used to transport fluid and gas in pneumatic, hydraulic, or process applications. Tubing differs from pipe in that tubing's outside diameter or size is controlled and used for product designation.
|
|
Valve actuators mount on valves and, in response to a signal, move a valve to a desired position using an outside power source.
|
