|
Click on a category to narrow your results.
|
|
|
Home
|
| |
|
|
|
Product Categories for current to voltage conversion
|
|
Machine Design Search Results for current to voltage conversion
Machine Design -
... input voltage; VOUT = output voltage; IOUT = output current, A; and IQ = quiescent current, A (standby current, no load).. It is good practice to keep TJ about 25°C below the maximum value specified ...
|
Machine Design -
... leakage current flow into or out of the device. The drawback with junction isolation is that it takes up wafer space and requires activation power. Breakdown voltage improvements in high-voltage ICs ...
|
Machine Design -
SCR voltage at the conduction point is called the breakover voltage. A signal applied to the gate terminal controls the level of breakover voltage. The higher the gate current, the lower the breakover ...
|
Machine Design -
... in either direction. When a small voltage of either polarity is applied across the diac, little current flows. Diac resistance remains high until applied voltage reaches a breakdown voltage point. At ...
|
Machine Design -
... voltage change over several cycles to prevent continuous ringing. Typically, line and load regulation for linears are about ten times better than switchers for the same voltage and current ratings. ...
|
Machine Design -
... and a feedback system which controls dc voltage as a function of speed. Adjustable-voltage dc drives are equally applicable to single or multiple-motor applications. The power-conversion unit can be ...
|
Machine Design -
... voltage, a feedback arrangement to monitor output voltage or current, a high-gain amplifier, and a series-pass element that regulates the output. The devices regulate output voltage by comparing it to ...
|
Machine Design -
Primary overcurrent protection for regulated power supplies is provided by a current-limiting feature that limits output from 10 to 50% above rated current. When that point is reached, voltage drops ...
|
Machine Design -
... protecting equipment from current overload because of a low-voltage condition. The normal range for undervoltage operation is 30 to 60% of line voltage. Generally, the voltage must be at least 80% ...
|
Machine Design -
In addition to detecting excessive current, voltage, and temperature, many power ICs also sense when a load has been disconnected and when load voltage falls below a safe level. Undervoltage warnings ...
|
|
|
|
