|
Click on a category to narrow your results.
|
 |
 |
Product Alerts
Keep current on the latest products, new suppliers, and technical articles of interest to you.
(See Topics)
|
|
|
Home
|
| |
|
|
|
Product Categories for input signal
|
|
Machine Design Search Results for input signal
Basics of Design Engineering - Fluid Power Chapter 4 - Hydraulic & Fluid ...
Due to hysteresis when cycling up and down, pressure differential can be as much as 4%. Usually, this is not a problem, because the input signal can be adjusted to compensate for the difference. ...
|
Basics of Design Engineering - Fluid Power Chapter 7 - Power Modulation and ...
... input signal. Positioning accuracy can be improved by removing the centering springs and adding a positioning sensor to the end of the spool. The sensor signal then cancels the solenoid signal when ...
|
Machine Design -
... input signal. Positioning accuracy can be improved by removing the centering springs and adding a positioning sensor to the end of the spool. The sensor signal then cancels the solenoid signal when ...
|
Fluid Power Monthly - June, 2007
... any open-loop single solenoid proportional valve rated from 0.5 to 3 A. Three-digit display shows input signal or output current and serves as a tune-up interface. Input signal can be selected from 0-5 ...
|
Machine Design -
Due to hysteresis when cycling up and down, pressure differential can be as much as 4%. Usually, this is not a problem, because the input signal can be adjusted to compensate for the difference. ...
|
Motion Control Chapter 2: Dedicated boards
... each of the input bits. Usually, however, both these isolation techniques are prohibitively expensive. Isolation is less expensive when the servocontroller generates a high-frequency PWM signal. A PWM ...
|
Basics of Design Engineering - Electrical/Electronic - I/O Devices - Gate turn-...
... If the SCS is turned on with the cathode-gate signal like a conventional SCR, a sufficiently positive signal on the anode gate will subsequently turn it off. A positive signal applied to both gates ...
|
Machine Design -
... If the SCS is turned on with the cathode-gate signal like a conventional SCR, a sufficiently positive signal on the anode gate will subsequently turn it off. A positive signal applied to both gates ...
|
Basics of Design Engineering - Electrical/Electronic - I/O Devices - Solid-state...
Dc input load-sensing modules perform a similar function for dc loads. Transducer-sensing input modules accept low-level signals from a specific transducer type, such as thermocouples or strain gages ...
|
Machine Design -
Dc input load-sensing modules perform a similar function for dc loads. Transducer-sensing input modules accept low-level signals from a specific transducer type, such as thermocouples or strain gages ...
|
|
|
|
