|
Click on a category to narrow your results.
|
 |
 |
Product Alerts
Keep current on the latest products, new suppliers, and technical articles of interest to you.
(See Topics)
|
|
|
Home
|
| |
|
|
|
Product Categories for signal conversion
|
|
Machine Design Search Results for signal conversion
Machine Design -
... If the SCS is turned on with the cathode-gate signal like a conventional SCR, a sufficiently positive signal on the anode gate will subsequently turn it off. A positive signal applied to both gates ...
|
Machine Design -
The signal from this encoder is used as a master position signal. The signal is sent both to the processor controlling the master axis and to the processors controlling other slaved axes in the system ...
|
Machine Design -
This low-current signal is amplified into either a pulse-width-modulated signal sufficient to drive proportional solenoids on the pump, or an amplified current signal to drive proportional pressure ...
|
Machine Design -
This produces an electrical signal proportional to displacement. An advantage of some capacitive accelerometers is that they are air damped. This makes their damping coefficient relatively insensitive ...
|
Machine Design -
The slider contains two coils spaced 90° apart. The coils inductively pick up the signal and produce an alternating voltage amplitude that is proportional to the sine and cosine of the slider position ...
|
Machine Design -
Unloading valves provide free passage through a low-pressure area when a signal is applied to a pilot connection. In a typical application, unloading valves can be arranged to accept a signal from an ...
|
Machine Design -
Their output, however, usually requires some voltage amplification before use as a command signal. A small dc amplifier is generally used to increase the sensor signal level. This amplification also ...
|
Machine Design -
... input signal. Positioning accuracy can be improved by removing the centering springs and adding a positioning sensor to the end of the spool. The sensor signal then cancels the solenoid signal when ...
|
Machine Design -
This so-called crosstalk is covered by ratings generally specified for a 10-ft length in percent of the signal strength of the adjacent conductor. Crosstalk is usually specified for signals having ...
|
Machine Design -
A gate signal need last from a few microseconds to milliseconds to fire an SCR into the forward-conducting state. Once it fires, the gate signal has no effect. The reverse characteristics of the SCR ...
|
|
|
|
